Silver HVAC Maintenance Plan

Silver HVAC Maintenance Plan

Plan Includes:

  • Precision Tune-Up For HVAC equipment
  • Combustion Adjustment, Professional Cleaning, & Safety Inspection
  • 10%Major Repair Discount

20 POINT CHECKLIST

  1. Inspect Burner Assembly to check combustion, reducing waste heat
  2. Inspect Burners for efficient burns, saving energy
  3. Inspect Ignition Assembly to ensure reliable operation on demand
  4. Inspect Furnace Heat Section to ensure safe operation and the absence of cracks from metal fatigue
  5. Verify Flue Draft to ensure dangerous gas by-products are properly venting to the outdoors and flue pipes are free from obstruction
  6. Inspect Flue Pipe to ensure no corrosion is present which can lead to cracks and the introduction of dangerous fumes into your home
  7. Check Refrigerant Charge to ensure optimum levels leading to lower utility usage and extend compressor life
  8. Inspect Capacitors to ensure reliable operation and continued compressor and motor protection
  9. Inspect Crankcase Heaters to ensure proper compressor protection
  10. Inspect Controls & Safeties to keep operating costs low and prevent failures
  11. Inspect Fan Switch to prevent wasted energy and excess sound levels from nuisance cycling
  12. Inspect Blower Assembly to extend motor life, improve air quality, and reduce sound
  13. Check Air Flow to ensure proper air flow across the coil for proper humidity removal and reliable operation
  14. Visually Inspect Ductwork to identify obvious leaks, which reduce system efficiency and increase utility expense
  15. Inspect Electrical Connections to ensure uninterrupted system operation
  16. Check Voltage & Amperage to identify baseline operating conditions
  17. Lubricate All Moving Parts to maintain efficiency and extend equipment life
  18. Inspect Inside Evaporator Coil to assess heat transfer efficiency
  19. Inspect Outside Condensing Coil to assess heat transfer efficiency
  20. Clean Condensate Drains to prevent water damage and the potential for mold formation