Gold HVAC Maintenance Plan
Plan Includes:
- Precision Tune-Up For HVAC equipment
- Combustion Adjustment, Professional Cleaning, & Safety Inspection
- FREE Condensate Stoppage cleaning within the year
- FREE Replacement of capacitor, contactor, hot surface ignitor, or flame sensor within the year
- FREE Priority Service
- 10% Major Repair Discount
24 POINT CHECKLIST
- Clean Burner Assembly to improve combustion, reducing waste heat
- Tune Burners for more efficient burns, saving energy
- Clean Ignition Assembly to ensure reliable operation on demand
- Clean & Inspect Furnace Heat Section to ensure safe operation and the absence of cracks from metal fatigue
- Verify Flue Draft to ensure dangerous gas by-products are properly venting to the outdoors and flue pipes are free from obstruction
- Inspect Flue Pipe to ensure no corrosion is present which can lead to cracks and the introduction of dangerous fumes into your home
- Calibrate Thermostat for accurate control and to prevent system from running longer than necessary, increasing utility usage
- Test Refrigerant Charge to ensure optimum levels leading to lower utility usage and extend compressor life
- Test Capacitors to ensure reliable operation and continued compressor and motor protection
- Test Crankcase Heaters to ensure proper compressor protection
- Inspect & Test Controls & Safeties to keep operating costs low and prevent failures
- Adjust Fan Switch to prevent wasted energy and excess sound levels from nuisance cycling
- Adjust Balancing Dampers to improve comfort
- Clean or Replace Filters to reduce energy use, reduce compressor strain, improve indoor air quality, and improve comfort
- Clean & Adjust Blower Assembly to extend motor life, improve air quality, and reduce sound
- Check Air Flow to ensure proper air flow across the coil for proper humidity removal and reliable operation
- Visually Inspect Ductwork to identify obvious leaks, which reduce system efficiency and increase utility expense
- Tighten Electrical Connections to ensure uninterrupted system operation
- Measure & Record Voltage & Amperage to identify baseline operating conditions
- Lubricate All Moving Parts to maintain efficiency and extend equipment life
- Clean Inside Evaporator Coil to restore heat transfer efficiency, reduce utility cost, and improve air quality
- Clean Outside Condensing Coil to restore heat transfer efficiency and reduce utility cost
- Clean Condensate Drains to prevent water damage and the potential for mold formation
- Replace capacitor, contactor, hot surface ignitor, or flame sensor if necessary